위 사진은 Headrush FRFR-112 의 스피커 후면입니다.

XLR 케이블을 꽂는것이 맞지만

상황과 여건에 따라 TRS 케이블을 꽂을때도 TS케이블을 꽂아야 할 때도 있습니다.

위 커넥터가 TS인지 TRS인지 구별할 수 있는 방법은 어떤 것이 있겠습니까?

이 질문에서 언급한 상품

헤드러시 FRFR-112 파워드 스피커 (MK-II)

기본 판매가 650,000원 · 일시 품절

상품 보기 →

오래된 답변의 사양·호환·가격·사은품 조건은 현재와 다를 수 있습니다. 할인 혜택과 최종 구성은 상품 페이지에서 확인해 주세요.

Headrush FRFR-112 메뉴얼 6페이지에 보시면 캐논잭이나 TRS 밸런스드 잭을 연결 가능하다고 나와 있습니다.

Rear Panel 

1. AC Input: Use the included power cable to connect this input to a power outlet. Make sure the Power Switch is set to off when connecting or disconnecting the cable. 

2. Fuse: If the unit’s fuse is broken, lift this tab to replace the fuse. Replace it with a fuse with an appropriate rating (printed under the unit’s power cable input). Using a fuse with an incorrect rating can damage the unit and/or fuse. 

3. Power Switch: Use this switch to power the loudspeaker on or off. Make sure the Volume knob is set to its minimum (counterclockwise) position before turning it on. 

4. Power LED: This LED lights up when the loudspeaker is on. 

5. Volume: Turn each knob to adjust the volume of each input. 

6. Input: Use a standard XLR cable or 1/4” (6.35 mm) TRS cable (not included) to connect your audio source to this input. 

7. Output: Use a standard XLR cable (not included) to connect this output to the input of another loudspeaker (i.e., another FRFR-112). 

8. Signal Limit LED: This LED lights up green when an audio signal is sent to the loudspeaker—it flashes at lower levels and lights solidly at higher levels. The LED lights up red when output limit/protection is active—if the LED is lit red continuously, reduce the volume of your audio source. 

9. Contour: Engage (depress) this button to emphasize low and high frequencies by +3 dB. Disengage (raise) the switch for a flatter response for live performance or for maximum output. 

10. Ground Switch: Engage (depress) this switch to reduce hum or noise.